- 09 Aug 2023
- 1 Minute to read
- DarkLight
- PDF
Enable Windows Updates on VR-X20
- Updated on 09 Aug 2023
- 1 Minute to read
- DarkLight
- PDF
Symptom
Windows Update is disabled by default on all Getac DVRs running Windows 10.
Resolution
If an admin would like to enable Windows Updates, the following procedure can be followed:
- Login to a local admin account on the DVR. Utilize the ClientAdmin account if no other local admin account was created.Note:Contact support@getacvideo.com to get the ClientAdmin password.
- Open an Administrative Command Prompt (WIN + X, then a).z
- Run the command:Text
Sc config wuauserv start=demand
- Close Command Prompt.
- Run the command:
- Open GPEdit (WIN + R, type gpedit.msc then hit the enter key).
- Navigate to Computer Configuration > Administrative Templates > Windows Components > Windows Update.
- Set Update the Configure Automatic Updates to enabled.
- Set the desired organization specific update settings.
- Set Remove access to use all Windows Update features to disabled
- Set Update the Configure Automatic Updates to enabled.
- Navigate to Computer Configuration > Administrative Templates > Windows Components > Windows Update.
- Reboot the DVR.
- Login to a local admin account on the DVR.
- Open GPEdit
- Navigate to Computer Configuration > Administrative Templates > Windows Components > Windows Update
- Set Update the Configure Automatic Updates to Not Configured
- Set Remove access to use all Windows Update features to Not Configured
- Navigate to Computer Configuration > Administrative Templates > Windows Components > Windows Update
- Reboot the DVR.